Listing 4.

## apcupsd.conf v1.1 ##<\n>
#
# ========= General configuration parameters ============
#
# defines the type of cable that you have.
UPSCABLE smart
#
# defines the type of UPS you have.
UPSTYPE smartups
#
# name of your serial port
DEVICE /dev/ttyS0
#
# path for serial port lock file
LOCKFILE /var/lock
#
# ======== configuration parameters used during power failures ==========
#
# If during a power failure, the remaining battery percentage
# (as reported by the UPS) is below or equal to BATTERYLEVEL,
# apcupsd will initiate a system shutdown.
BATTERYLEVEL 5
#
#
# If during a power failure, the remaining runtime in minutes
# (as calculated internally by the UPS) is below or equal to MINUTES,
# apcupsd, will initiate a system shutdown.
MINUTES 3
#
#
# If during a power failure, the UPS has run on batteries for TIMEOUT
# many seconds or longer, apcupsd will initiate a system shutdown.
# A value of 0 disables this timer.
TIMEOUT 0
#
#
# Time in seconds between annoying users to signoff prior to
# system shutdown. 0 disables.
ANNOY 300
#
# Initial delay after power failure before warning users to get
# off the system.
ANNOYDELAY 60
#
# The condition which determines when users are prevented from
# logging in during a power failure.
NOLOGON disable
#
# ==== Configuration statements the network information server =========
#
# information server. If netstatus is on, a network information
# server process will be started for serving the STATUS and
# EVENT data over the network (used by CGI programs).
NETSERVER on
#
# port to use for sending STATUS and EVENTS data over
# the network.
# It is not used unless NETSERVER is on. If you change this port,
# you will need to change the corresponding value in the cgi directory
# and rebuild the cgi programs.
SERVERPORT 7000
#
# If you want the last few EVENTS to be available over the network
# by the network information server, you must define an EVENTSFILE.
# Only the last 50 or so events are kept.
EVENTSFILE /etc/apcupsd/apcupsd.events
#
# ===== Configuration statements to control apcupsd system logging ========
#
# Time interval in seconds between writing the STATUS file; 0 disables
STATTIME 60
#
# Location of STATUS file (written to only if STATTIME is non-zero)
STATFILE /etc/apcupsd/apcupsd.status
#
# You probably do not want this on.
LOGSTATS off
#
# Time interval in seconds between writing the DATA records to
# the log file. 0 disables.
DATATIME 0
#
# ========== Configuration statements used if sharing =============
#            a UPS and controlling it via the network              
#
# normally standalone unless you share a UPS with multiple machines.
UPSCLASS netslave
#
# Unless you want to share the UPS (power multiple machines).
# this should be disable
UPSMODE net
#
#NETACCESS <string> [ true | false ] Enable Network Access Support
NETACCESS true
#
# NETTIME <int>
NETTIME 60
#
# NETPORT <int>
NETPORT 6666
#
# MASTER <string>
MASTER my.network.master.com
#
# USERMAGIC <string>
USERMAGIC some_unique_string